Carbon Brush
A carbon brush is a sliding contact used in Brushed Motors and generators to transport electrical current from a static to a revolving part while assuring spark-free commutation.
End Shield
That part of the motor housing which supports the bearing and acts as a protective guard to the electrical and rotating parts inside the motor. This part is frequently called the "end bracket" or "end bell".
FC Unit
The induction motor takes a high no-load current lagging the applied voltage by a large angle
Filter Pad
Our filter pads are made of polyester fibers loosely woven and bonded together. Water slips between the fibers, but the junk floating in the water gets caught. The thicker the pad is and the longer it takes water to get through it, the more debris it will catch.
Force Cooling Unit
Forced-air cooling is accomplished by exposing packages of produce in a cooling room to higher air pressure on one side than on the other.
Force Cooling Unit
Forced-air cooling is accomplished by exposing packages of produce in a cooling room to higher air pressure on one side than on the other.
Rotor Hub
Rotor Hubs. The rotor hub is the component that usually holds the blades and connects them to the main shaft of the wind machine. It is a key component not only because it holds the blades in their proper position for maximum aerodynamic efficiency, it also rotates to drive the generator.